small fonts when copying

lisamark0822 · Post by **lisamark0822** » Wed Feb 09, 2005 11:00 pm

Whenever I do a cut and paste into textpad, the font size is 6. I have to select all and change the font size to 10. Why is this happening? What can I do to fix it.

s_reynisson · Post by **s_reynisson** » Wed Feb 09, 2005 11:10 pm

Close all open documents in TP. Goto Configure->Preferences->Document Classes->Default->Font. Select size 10, click Apply and OK.

lisamark0822 · Post by **lisamark0822** » Wed Feb 09, 2005 11:18 pm

I tried what you said and it didn't work. I am trying to copy text from a store procedure builder to textpad. When I highlight all the text I want to copy and press control C, then go to textpad and press control V, the font size is 6.

Thanks,

Mark

s_reynisson · Post by **s_reynisson** » Thu Feb 10, 2005 12:05 am

The document you are pasting into in TP must belong to a Document Class, the filename ending will tell you. Change the font size for that class, after closing all open documents. HTH

lisamark0822 · Post by **lisamark0822** » Thu Feb 10, 2005 12:19 am

Hi again,

When I go into textpad the document name is document1. By just looking at the cursor size I can tell it is 6 point. I closed all documents and went into the preferences and the font size for the default is 10. I rehighlighted the 10, clicked on apply, then ok. I then opened a new document called document2. I still get 6 point font. Am I doing something wrong? Could there be a corrupt config file somewhere?

Thanks,

Mark

Post by **MudGuard** » Thu Feb 10, 2005 12:42 am

Do you have any document class that contains files that match the pattern *.

If so, what is the font size setting for that class?

lisamark0822 · Post by **lisamark0822** » Thu Feb 10, 2005 12:51 am

The default class has the pattern *.* and the text class has the pattern *.

Both have the font size as 10.