Hello, I am migrating to a Windows 7 pro-64 workstation from a WinXP-sp3 based system.
I had an 8051 assembler setup to run as a tool in Textpad.
I made all the same configuration setings on the new system but I can't get any output.
The tool output window gives the following message,"Tool completed with exit code 3."
Any suggestions?
Thanks,
Bob
Tool setup - Windows 7 pro-64
Moderators: AmigoJack, bbadmin, helios, Bob Hansen, MudGuard
We had a similar problem on my colleague's machine.
The only one tool he had configured didnt work.
So I configured a different tool, just to see whether tools do not work at all.
Surprise: when there was a second tool, the first tool worked, and the second tool also worked.
So I deleted the second tool again. And surprise: first tool did not work anymore.
Configured a second tool again. Both tools worked ...
The only one tool he had configured didnt work.
So I configured a different tool, just to see whether tools do not work at all.
Surprise: when there was a second tool, the first tool worked, and the second tool also worked.
So I deleted the second tool again. And surprise: first tool did not work anymore.
Configured a second tool again. Both tools worked ...