hi,
i need your help! i accidently save my "patrans.ses.01" as a textpad default. how can i remove textpad default from this extension..?
thank you everyone!
patran .ses .01
Moderators: AmigoJack, bbadmin, helios, Bob Hansen, MudGuard
-
Bob Hansen
- Posts: 1516
- Joined: Sun Mar 02, 2003 8:15 pm
- Location: Salem, NH
- Contact:
If you made the association through TextPad, then undo it the same way:
Configure/Preferences/File associations/ Remove the extension from the center column by highlighting it and clicking Delete. Then Apply and OK your way out.
When making configuration changes I find it best to follow these steps, especially for any changes in Classes:
1. Close all other copies of TextPad.
2. Close all open documents, INCLUDING THE DEFAULT NEW BLANK DOCUMENT.
3. Make the changes you want: Configure/Preferences/......
4. Apply and OK your way out the configurations.
5. Close TextPad.
6. Open TextPad again, and your changes should be good.
------------------------
If you did not make the association using TextPad, then use Windows Control Panel/Folder Options. Click on the tab for File Types and delete/modify the extension as needed.
Configure/Preferences/File associations/ Remove the extension from the center column by highlighting it and clicking Delete. Then Apply and OK your way out.
When making configuration changes I find it best to follow these steps, especially for any changes in Classes:
1. Close all other copies of TextPad.
2. Close all open documents, INCLUDING THE DEFAULT NEW BLANK DOCUMENT.
3. Make the changes you want: Configure/Preferences/......
4. Apply and OK your way out the configurations.
5. Close TextPad.
6. Open TextPad again, and your changes should be good.
------------------------
If you did not make the association using TextPad, then use Windows Control Panel/Folder Options. Click on the tab for File Types and delete/modify the extension as needed.
Hope this was helpful.............good luck,
Bob
Bob
patran.ses.01
Thank you Bob for your help!