ANSI Charactes covering text

[MarkN]

Hi,

If I open a .txt file in TextPad 8.4.0 and then open the ANSI Characters, the latter appears over the text. So that if I want to add one of the ANSI characters to the text, I cannot.

This was not the case in TextPad 4.7 which I used before upgrading to 8.4.0.

Is there some way to prevent this from happening?

[MarkN]

Hi again,

Duh!

It finally occurred to me to look in the Help section... and there was the answer I needed:-

Place the cursor where you want to add the ANSI character, open the Clip Library and DOUBLE click on the desired ANSI character.

So simple!