i defined a bounch of macro with textpad on one computer(comp1). now on another computer(comp2), which has textpad installed as well, i would like to use those macro defined on comp1.
is there any way i can copy or whatever procedure from comp1, instead of re-defining those macro on comp2? thanks
share macros in textpad on two computer
Moderators: AmigoJack, bbadmin, helios, Bob Hansen, MudGuard
-
Bob Hansen
- Posts: 1516
- Joined: Sun Mar 02, 2003 8:15 pm
- Location: Salem, NH
- Contact:
Put the macros in a shared folder on the network. Then set the path for the macro folders to that shared folder using
Configure/Preferences/Folders/Macros
When making configuration changes I find it best to follow these steps, especially for any changes in Classes:
1. Close all other copies of TextPad.
2. Close all open documents, INCLUDING THE DEFAULT NEW BLANK DOCUMENT.
3. Make the changes you want: Configure/Preferences/......
4. Apply and OK your way out the configurations.
5. Close TextPad.
6. Open TextPad again, and your changes should be good.
Configure/Preferences/Folders/Macros
When making configuration changes I find it best to follow these steps, especially for any changes in Classes:
1. Close all other copies of TextPad.
2. Close all open documents, INCLUDING THE DEFAULT NEW BLANK DOCUMENT.
3. Make the changes you want: Configure/Preferences/......
4. Apply and OK your way out the configurations.
5. Close TextPad.
6. Open TextPad again, and your changes should be good.
Hope this was helpful.............good luck,
Bob
Bob