Split window but not follow.

[tcebob]

Is it possible? I want to compare two similar areas in the same file.

tcebob

[helios]

Try using the Split command from the Window menu, but make sure that Synchronized scrolling is not enabled on the Configure menu.

I hope this helps.

[tcebob]

Yes, it's right there on the config pull-down. But it only works in one direction. What I had in mind was 2 vertical views of the same file but in different places. This would greatly facilitate cloning repetitive code or checking for small differences. I resolved the problem by making a copy of the file and opening it in a new window. Not very efficient but it will have to do, I gusee, until the next update. You think?

rs

[tcebob]

Admittedly, I don't gusee very much any more. But I still supoose.

rs

[boldan]

I resolved the problem by making a copy of the file and opening it in a new window. Not very efficient but it will have to do, I gusee, until the next update.

That's a good idea to open a copy of the file. Then tile vertically.