select entire line

Kevin · Post by **Kevin** » Fri Aug 15, 2003 4:34 pm

Can I select the entire line by clicking on the line number(s)?

Bob Hansen · Post by **Bob Hansen** » Fri Aug 15, 2003 5:05 pm

Double click, not single click. But note, the selected section is the ine, not the paragraph, so be sure about your word wrap setting. Word wrap must be off to select a full paragraph by double clicking the line number.

Hope this helps...................good luck,
Bob

Kevin · Post by **Kevin** » Sat Sep 06, 2003 9:11 pm

I finally found the answer I was looking for. In the editor preferences:

Use Microsoft's conventions for mouse click selection. Change the default double click in the left margin, to select a line, to a single click.

I knew there was a way to do it. I just didn't look hard enough.

Thanks anyway Bob.