2 Problems with 4.7.1
Posted: Sat Aug 30, 2003 2:33 pm
Hi,
Helios thanks a LOT for beeing so much more responsive to user wishes!!!!
And a special thank you for the current line highlighting!
Anyway, I ran into two problems:
1 Since I installed 4.7.1 I get this, ... er ..., behaviour
I write some script...
... save the work in a workspace
... run it by using the appropriate tool
... see the result in the 'Command Output' window
... close TextPad
... reopen it and
The output window it not displayed. Instead the area where the window should be displayed is filled with what ever was on the sceen on the monitor.
However, when I switch to another window and back again will show the output.
2 Sometime I get a "such-and-so" general protection fault right after starting the Ruby interpreter.
BTW, I'm running Ruby 1.8.0 on a Win98SE machine.
Has anyone else similar problems? Or even a workaround? (Note that neither dropping Ruby nor switching to another editor is an option fro me.
)
Cheers
Stephan
Helios thanks a LOT for beeing so much more responsive to user wishes!!!!
And a special thank you for the current line highlighting!
Anyway, I ran into two problems:
1 Since I installed 4.7.1 I get this, ... er ..., behaviourI write some script...
... save the work in a workspace
... run it by using the appropriate tool
... see the result in the 'Command Output' window
... close TextPad
... reopen it and
The output window it not displayed. Instead the area where the window should be displayed is filled with what ever was on the sceen on the monitor.
However, when I switch to another window and back again will show the output.
2 Sometime I get a "such-and-so" general protection fault right after starting the Ruby interpreter.BTW, I'm running Ruby 1.8.0 on a Win98SE machine.
Has anyone else similar problems? Or even a workaround? (Note that neither dropping Ruby nor switching to another editor is an option fro me.
) Cheers
Stephan