Community

Hi,

If I open a .txt file in TextPad 8.4.0 and then open the ANSI Characters, the latter appears over the text. So that if I want to add one of the ANSI characters to the text, I cannot.

This was not the case in TextPad 4.7 which I used before upgrading to 8.4.0.

Is there some way to prevent this from happening?

Hi again,

Duh!

It finally occurred to me to look in the Help section... and there was the answer I needed:-

Place the cursor where you want to add the ANSI character, open the Clip Library and DOUBLE click on the desired ANSI character.

So simple!