Getting Texpad to state the ANSI code of a character
Posted: Tue Sep 30, 2014 7:35 pm
Hi
I've read that if you move the mouse cursor over a character that Textpad will announce the ANSI code of the character. But this doesn't always work. Sometimes I would stand the cursor over the character for many seconds and nothing happens.
Is there a way to force Textpad to tell me the ANSI code of a character?
Sometimes what I end up doing is switching the view to hex mode and calculate the ANSI number from the hex.
Either I'm doing something wrong or there must be a better way I don't know about.
Thanks in advance.
I've read that if you move the mouse cursor over a character that Textpad will announce the ANSI code of the character. But this doesn't always work. Sometimes I would stand the cursor over the character for many seconds and nothing happens.
Is there a way to force Textpad to tell me the ANSI code of a character?
Sometimes what I end up doing is switching the view to hex mode and calculate the ANSI number from the hex.
Either I'm doing something wrong or there must be a better way I don't know about.
Thanks in advance.