TP 5: Customize toolbars - can remove but can't add commands

[cv]

When using the 'customize' function (commands tab) against the tool bars, I can remove commands from a given tool bar, but I can't add new ones. As soon as I select a command from the dialog window and try to slide it to the tool bar, the cursor behaves as if I wanted to delete (small 'X') and the tool bar doesn't receive the command.

Oddly enough, I can slide a command to any menu bar item.

[gspatel62]

When using the 'customize' function (commands tab) against the tool bars, I can remove commands from a given tool bar, but I can't add new ones. As soon as I select a command from the dialog window and try to slide it to the tool bar, the cursor behaves as if I wanted to delete (small 'X') and the tool bar doesn't receive the command.

Oddly enough, I can slide a command to any menu bar item.

How odd. I have exactly the reverse problem! I can slide a command to any toolbar but not to any menu! When I try moving a command to a menu, I get the small X and the menu doesn't receive the command.

[cv]

My issue was fixed in the latest release.

[gspatel62]

Guess you're the lucky one then,

My issue persists -- I still cannot add any of the widgets from the Command dialog to the Menu bar. Though I can add a New Menu, even rename it, but what good is that if I can't put a command under it?!!?

[cv]

You're right. I get the same results

[gspatel62]

I took the plunge, steeled myself against all the dire-sounding warnings ("check the forums!" "have you checked the forums?" "look at the faq!") and wrote to techsupport about this.

A very short while later, I got this response:

You are right about this, so thanks for bringing it to our attention.

It's very encouraging to get a response from support so quickly, and I can only hope we'll have the issue resolved soon. In the meantime, we muddle along.